From grout surface treatment to full wall cavity remediation — the right scope for your specific bathroom mold situation in DuPont, WA.
🔍
Bathroom Mold Investigation & Source Identification
Before any tile comes off or drywall opens, our DuPont, WA bathroom mold specialists perform a systematic investigation: moisture meter readings at all suspect zones (shower walls, floor at shower pan perimeter, toilet base, under-sink cabinet), borescope inspection of wall cavities through access points, exhaust fan CFM measurement, and visual assessment of grout and caulk integrity. Written findings before scope is proposed.
🚿
Shower & Tub Surround Mold Remediation
Surface grout mold, backer board mold, and cavity mold behind shower walls are three distinct situations requiring different approaches. We identify which applies to your DuPont, WA shower before proposing any tile removal or wall opening.
💧
Subfloor Mold Removal — Toilet Leaks & Shower Pan Failure
A slow toilet wax ring leak or cracked shower pan can saturate subfloor material for months before any visible symptoms appear above the surface. By the time vinyl or tile shows staining or soft spots, the subfloor below often has significant mold growth. Our DuPont, WA team removes contaminated subfloor sections, treats remaining structural material, and specifies the appropriate replacement — SBC, CPP, or cement backer depending on application.
🔢
Exhaust Fan Assessment & Upgrade Recommendation
Inadequate bathroom exhaust fan CFM is a primary cause of chronic bathroom mold on drywall and ceiling surfaces in DuPont, WA homes. We measure existing fan output, compare against HVI recommended CFM for your bathroom square footage, and specify an appropriate replacement if the existing fan is undersized — a simple correction that dramatically changes long-term mold risk.
🌟
Ceiling Mold — Condensation & Leak Sources
Bathroom ceiling mold occurs in two distinct scenarios: condensation from chronic inadequate ventilation (which leaves a diffuse, widespread pattern on the ceiling surface), and drip from a bathroom above (which creates a concentrated pattern tracing the path of the drip). Our DuPont, WA team distinguishes between these, addresses the correct source, and remediates accordingly — surface treatment for condensation mold, cavity investigation and source repair for drip sources.
📄
Post-Remediation Clearance & Documentation
Independent post-removal air sampling before any reinstallation begins. Written clearance report confirms the mold is gone before new materials go in.